01
Inspection and Moisture Mapping
A certified technician walks the property with a thermal imaging camera and moisture meter, checking wall cavities, ceilings, and subfloor. We photograph every reading and identify the water source. This usually takes 45 to 90 minutes depending on square footage, and you get a written scope before any work begins.
02
Containment and Negative Pressure
We build a sealed work zone using polyethylene sheeting, duct tape, and zipper doors, then set an Abatement Technologies negative air machine to keep the containment under pressure. HEPA air scrubbers run continuously. This step protects the rest of your home and typically takes 60 to 120 minutes to set up.
03
Removal and HEPA Vacuuming
Porous materials with active growth come out: drywall, insulation, carpet, and damaged framing. Every remaining surface gets HEPA vacuumed with a ProTeam or RIDGID unit, then treated with a biocide solution. Technicians wear full personal protective equipment, and debris leaves in sealed bags. Most removal days run 4 to 8 hours.
04
Drying and Antimicrobial Treatment
Dri-Eaz and Phoenix Restoration dehumidifiers pull moisture from the structure until readings match dry-standard baselines, which usually takes 2 to 4 days. We apply an antimicrobial coating to framing and cavities, and use dry ice blasting on tough framing lumber where abrasive cleaning would cause damage.
05
Clearance Testing and Report
An independent air sampling pump test confirms spore counts are back to normal outdoor levels. You receive the lab report, photo documentation, and a written summary of what was removed and what was treated. If clearance fails, we re-clean before we close the job.