01
Inspect and Trace
We arrive with a thermal imaging camera, a moisture meter, and a boroscope camera for wall cavities. The inspection takes 45 to 90 minutes. We map the moisture plume, photograph affected materials, and identify the source, whether that is a failed shower pan liner, a leaking valve, or a roof leak above the ceiling.
02
Contain and Protect
We hang polyethylene sheeting with zipper doors, seal HVAC registers with duct tape, and set a negative air machine with HEPA filters. Technicians wear personal protective equipment including respirators and Tyvek suits. Containment goes up before any material is disturbed, which keeps spore counts down in the rest of the house.
03
Remove and Treat
We cut out mold-damaged drywall, insulation, and caulk, bag it, and haul it out through the containment. Exposed framing gets HEPA vacuuming followed by a biocide solution or Concrobium treatment. Porous materials come out; solid framing stays and gets cleaned. This stage typically takes one to two days.
04
Dry and Verify
Dri-Eaz dehumidifiers and air scrubbers run until moisture readings return to normal for the material type. Then we collect air samples with an air sampling pump and send them to a lab. Clearance results usually come back in 24 to 48 hours, and we review them with you line by line.
05
Rebuild and Prevent
Once clearance passes, we install mold-resistant drywall, tape and texture, and set new caulk lines. We size and install the exhaust fan if the existing one is underpowered, and we leave you with a written moisture-control routine. Final walkthrough takes about 30 minutes.